Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 35

Bearbeitet von David Hodson -

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Use a plastic spudger to pry the metal rings on the battery connectorsterminals up so that they are verticalperpendicular to the battery terminals.
[* icon_note] These rings should be on the same end as the leads sticking out the sides of the circuit boardsurface mount leads. If they are on the opposite endends, the board is on backwards. Unscrew the nuts and flipnuts, rotate the circuit board around180°, reinstall the nuts, and tighten the two screws.
[* black] Use a plastic spudger to pry the metal rings on the battery connectorsterminals up so that they are verticalperpendicular to the battery terminals.
[* icon_note] These rings should be on the same end as the leads sticking out the sides of the circuit boardsurface mount leads. If they are on the opposite endends, the board is on backwards. Unscrew the nuts and flipnuts, rotate the circuit board around180°, reinstall the nuts, and tighten the two screws.