Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 3

Bearbeitet von Brian Smith -

Wartet auf Freigabe

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Starting at a bottom corner, use the spudger to separate the rear case from the front display.
[* black] Move your way around towards the top on both sides. The plastic opening tool is easier to use for this step.
[* icon_caution] Detaching the top is somewhat tricky. InsertMake sure the spudger intoonly thing holding it together is the top corner, slidecenter. Gently bend back both top corners slightly bowing the top of the back cover. While holding it toin this bowed state you can then sides the middle,whole back cover down and apply downward forceit detaches with ease. It helps to unhookpush in on the clip.top back center while you bent back the sides/top corners. Note: The clip is quite large so this may require a bitback cover can not slide until the sides are not just detached but held back out of forcethe way. Trying to force the catch off any other way requires lots of force and may brake the catch.
[* icon_caution] Detaching the top is somewhat tricky. InsertMake sure the spudger intoonly thing holding it together is the top corner, slidecenter. Gently bend back both top corners slightly bowing the top of the back cover. While holding it toin this bowed state you can then sides the middle,whole back cover down and apply downward forceit detaches with ease. It helps to unhookpush in on the clip.top back center while you bent back the sides/top corners. Note: The clip is quite large so this may require a bitback cover can not slide until the sides are not just detached but held back out of forcethe way. Trying to force the catch off any other way requires lots of force and may brake the catch.