| - | [* black] To remove the drive clip, remove the one screw from the left side that holds the drive in. Use a ***Phillips #0*** bit for this step. |
|---|
| - | [* black] Once the screw is removed, pull the clip off from the left side of the drive clip. |
|---|
| - | [* icon_note] The right side of the clip is used for drive alignment. Because of this, there is no screw on the right side of the drive clip. |
|---|
| - | [* icon_reminder] If you are using this guide to remove the hard drive to install into another Dell computer that uses the same clip or removing it before sending the system to Depot, these steps are not required. |
|---|
| + | [* icon_note] This step is not required if you are moving the drive to a Dell computer with the same mounting bracket or for Depot service and want to retain the hard drive. |
|---|
| + | [* red] To remove the drive clip, remove the ***Phillips #0*** screw holding the hard drive to the clip. |
|---|
| + | [* orange] Once the screw is removed, remove the drive starting from the side with the screw. |
|---|
| + | [* yellow] Remove the drive from the right side by removing the drive from the alignment pin. |
|---|