Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 3

Bearbeitet von machv5 -

Bearbeitung abgelehnt von David Hodson

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Use a spudger or 'Open Pry tool' to disconnect ribbon cable(s) 1, 2, and 3the molex connectors for the LCD & Digitizer flexcable(s) #1 & #2.
[* black] Just a reminder. The 3rdThere is another cable is actually connected tounderneathe the boardfirst two molex connectors that is secured by a port, which requires an insetjawbone connector. gently pry up from the system board. When don correctly it will fold in half. You don't need a lot of force to do this. And be careful not to pry the whole assembly from the board. This can happen quite easily.
[* icon_reminder] Lift up the black tab on the back of the insetjawbone connector port, and then the 3rd ribbon should slide right out. Note: make sure that the jaw is in the upwards position when reassembling or the cable will not be able to seat properly.
[* black] Use a spudger or 'Open Pry tool' to disconnect ribbon cable(s) 1, 2, and 3the molex connectors for the LCD & Digitizer flexcable(s) #1 & #2.
[* black] Just a reminder. The 3rdThere is another cable is actually connected tounderneathe the boardfirst two molex connectors that is secured by a port, which requires an insetjawbone connector. gently pry up from the system board. When don correctly it will fold in half. You don't need a lot of force to do this. And be careful not to pry the whole assembly from the board. This can happen quite easily.
[* icon_reminder] Lift up the black tab on the back of the insetjawbone connector port, and then the 3rd ribbon should slide right out. Note: make sure that the jaw is in the upwards position when reassembling or the cable will not be able to seat properly.