Zum Hauptinhalt wechseln

Änderungen an Schritt Nr. 11

Bearbeitet von Ben Gottemoller

Bearbeitung genehmigt von Ben Gottemoller

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[title] Remove the top cover and observe burr holder gap
[title] Remove the top cover and observe burr holder gap
[* black] Carefully lift off the top and flip it to the side. It will hang from the few wires going to the control knob.
[* black] Take note that the chrome grind adjuster is fineset to '''fine''' and the stop-screw in the third pic is up against the plastic stopstop pointed to by the bottom yellow arrow.
[* black] Finally, take a photo of the gap between the lip of the "upper burr holder" and the internal "grind adjustment cylinder" illustrated in the third picture by the green arrows. At reassembly later it will be very important we get back to this gap. Having a photo will help you know you have succeeded
.
[* black] Take note that the chrome grind adjuster is fineset to '''fine''' and the stop-screw in the third pic is up against the plastic stopstop pointed to by the bottom yellow arrow.
[* black] Finally, take a photo of the gap between the lip of the "upper burr holder" and the internal "grind adjustment cylinder" illustrated in the third picture by the green arrows. At reassembly later it will be very important we get back to this gap. Having a photo will help you know you have succeeded
.

Bild 3

Alte Version

Neue Version