Änderungen an Schritt Nr. 2

Bearbeitet von Christopher Hill -

Bearbeitung abgelehnt von Jake Devincenzi

Gelöscht
Hinzugefügt
Unverändert

Schritt-Zeilen

[* black] Disconnect the microphone cable connector, removing tape as necessary.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* black] If you are not removing the bezel, but just trying to access the internals, then you can leave the microphone cable attached and just lift the bottom of the bezel up and over the computer so that it rests face down. There is enough microphone cable to allow them to remain connected if you have the room.