Einleitung
This guide is an internal private guide that serves as a prereq.
Was du brauchst
-
-
Remove the large piece of tape near the lower right corner of the display.
-
-
-
Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws).
-
Use the tip of a spudger to remove the small washer under the screw you just removed.
-
-
-
Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.
-
-
-
-
Remove the pieces of readily removable tape from around the perimeter of the display.
-
-
-
Remove the piece of aluminum tape near the center of the LCD cover.
-
Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.
-
-
-
Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
