Repariere deine Sachen Community Shop

iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement

Einleitung

Replacing this keyboard is easy and takes only a few minutes.

Was du brauchst

  1. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Battery: Schritt 1, Bild 1 von 1

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    Übersetzen

  2. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 2, Bild 1 von 1

    • Lift the battery out of the computer.

    Übersetzen

  3. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Keyboard: Schritt 3, Bild 1 von 1

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    Übersetzen

  5. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 4, Bild 1 von 1

    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

    Übersetzen

  6. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 5, Bild 1 von 1

    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

    Übersetzen

  7. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 6, Bild 1 von 1

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    Übersetzen

  8. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 7, Bild 1 von 1

    • Remove the four silver Phillips screws that secure the RAM shield.

    Übersetzen

  9. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 8, Bild 1 von 1

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    Übersetzen

  10. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: Schritt 9, Bild 1 von 1

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Personen haben diese Anleitung absolviert.

Angehängte Dokumente

Autor:in

mit 6 anderen Mitwirkenden

iRobot

Mitglied seit: 09/24/09

1 Reputation

636 Anleitungen geschrieben

Auszeichnungen: 36

+ 33 weitere Auszeichnungen

0 Kommentare zur Anleitung

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 2

Letzte 30 Tage: 10

Insgesamt: 12,368