Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

Kommentar hinzufügen

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

Kommentar hinzufügen

Carefully remove the base access panel.
  • Carefully remove the base access panel.

Kommentar hinzufügen

Remove the four 25mm T-15 screws. Remove the four 25mm T-15 screws.
  • Remove the four 25mm T-15 screws.

Kommentar hinzufügen

Open the housing plate. Be gentle with the wires still connected to the logic board  so as not to ruin the cables.
  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Kommentar hinzufügen

Remove the 2 torx 10mm screws on the EMI shield Carefully remove shield and copper tape Carefully remove shield and copper tape
  • Remove the 2 torx 10mm screws on the EMI shield

  • Carefully remove shield and copper tape

Kommentar hinzufügen

Remove the 4 10mm torx screws attatched to the drive carrier. The drive carrier includes optical drive and hard drive.
  • Remove the 4 10mm torx screws attatched to the drive carrier.

  • The drive carrier includes optical drive and hard drive.

Kommentar hinzufügen

Grasp the carrier with both hands on each side.
  • Grasp the carrier with both hands on each side.

  • Remove the carrier by lifting up and out.

  • Pull gently but firmly. The carrier is meant to fit snugly.

Kommentar hinzufügen

Flip the removed carrier to the right and pull out power cables.
  • Flip the removed carrier to the right and pull out power cables.

Kommentar hinzufügen

Peel back the white paper, revealing the screws that connect the hard drive to the carrier. Remove the 4 T-10 5mm screws connecting the hard drive and frame. (There are 2 screws on each side) Remove the 4 T-10 5mm screws connecting the hard drive and frame. (There are 2 screws on each side)
  • Peel back the white paper, revealing the screws that connect the hard drive to the carrier.

  • Remove the 4 T-10 5mm screws connecting the hard drive and frame. (There are 2 screws on each side)

Kommentar hinzufügen

Slide the hard drive out from the frame and optical drive.
  • Slide the hard drive out from the frame and optical drive.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

17 weitere Nutzer haben diese Anleitung absolviert.

Courtney

Mitglied seit 06.10.2011

734 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 21-22, Maness Fall 2011 Mitglied von Cal Poly, Team 21-22, Maness Fall 2011

CPSU-MANESS-F11S21G22

4 Mitglieder

13 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 19

Letzte 30 Tage: 54

Insgesamt: 7,027