Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lay the iMac display-side down on a flat surface (putting a cloth under the screen to protect it from bumps).
-
Loosen the three Phillips screws securing the rear panel to the iMac.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the rear panel slightly near the bottom of the iMac.
-
Pull the rear panel toward yourself and remove it from the iMac.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the following three screws:
-
One shouldered 12.4 mm Phillips.
-
Two 7 mm T10 Torx.
My model have 3 phillips screws, no torx
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the hard drive slightly and disconnect the hard drive thermal sensor connector.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Insert the flat end of a spudger into the gap between the SATA data connector and the hard drive.
-
Twist the spudger to separate the SATA data connector from the hard drive, then disconnect it from the hard drive.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the hard drive out of the iMac.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two 15 mm shouldered T10 Torx screws from the hard drive and remove the bracket.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two 6 mm T10 Torx screws from the hard drive and remove the hard drive bracket.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
149 weitere Nutzer:innen haben diese Anleitung absolviert.
Some models (with light sensor) have only the two outboard screws.
Robert Huber - Antwort