Einleitung
This guide is an internal prerequisite and should remain unpublished.
Was du brauchst
-
-
Pull the optical drive thermal sensor connector straight away from its socket on the logic board.
-
-
-
Remove the four 9 mm T10 Torx screws securing the optical drive to the outer case.
-
-
-
-
Lift the inner edge of the optical drive and maneuver its connector past the frame attached to the logic board.
-
Carefully pull the optical drive off its mounting pins on the edge of the outer case to gain clearance for disconnecting the optical drive cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.