Einleitung
Prereq only
Was du brauchst
-
-
Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.
-
-
-
Remove the two T10 Torx screws securing the upper hard drive bracket to the outer case.
-
-
-
-
Slightly rotate the hard drive away from the outer case.
-
Lift the hard drive off its two lower positioning pins and remove it from the outer case.
-
-
-
Remove the two T8 Torx screws securing the upper bracket to the hard drive.
-
Remove the upper bracket from the hard drive.
-
-
-
Carefully peel off the piece of EMI foam attached to the front of the hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.