Einleitung
Internal prereq removal with front panel already removed.
Was du brauchst
-
-
Use the edge of a plastic opening tool to flip up the retaining flap on the headphone jack and front camera cable ZIF socket.
-
Peel the headphone jack and front camera cable off the rear case.
-
-
-
Pull the headphone jack and front camera ribbon cable straight out of its socket on the logic board.
-
-
-
Remove the three 2 mm Phillips screws securing the SIM card slot to the rear panel.
-
-
-
-
Remove the two 2.9 mm Phillips screws securing the headphone jack to the top edge of the rear panel.
-
-
-
Use a plastic opening tool to help pull the headphone jack out of its recess in the top of the rear panel.
-
-
-
Carefully remove the strip of tape covering the front camera cable connector.
-
Use a plastic opening tool to disconnect the front camera cable from the microphone cable immediately below it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
