Repariere deine Sachen Community Store

iPad 2 GSM Headphone Jack Assembly Replacement

Grundständige Anleitung
Dies ist eine grundständige Anleitung, die nur als Teil einer anderen Anleitung verwendet werden sollte.

Einleitung

Prerequisite only.

Was du brauchst

  1. iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: Schritt 1, Bild 1 von 3 iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: Schritt 1, Bild 2 von 3 iPad 2 GSM Headphone Jack Assembly Replacement, Headphone Jack Assembly: Schritt 1, Bild 3 von 3

    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

    Übersetzen

  2. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 2, Bild 1 von 1

    • Remove the three 2 mm Phillips screws securing the SIM slot to the rear panel.

    Übersetzen

  3. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 3, Bild 1 von 1

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

    Übersetzen

  5. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 4, Bild 1 von 1

    • Use a plastic opening tool to help pull the headphone jack away from its recess in the top edge of the iPad.

    • Don't try to remove the assembly just yet.

    Übersetzen

  6. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 5, Bild 1 von 1

    • Carefully peel the front camera and microphone cables off the rear panel.

    Übersetzen

  7. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 6, Bild 1 von 2 iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 6, Bild 2 von 2

    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

    Übersetzen

  8. iPad 2 GSM Headphone Jack Assembly Replacement: Schritt 7, Bild 1 von 1

    • Carefully peel the front camera cable off the bottom ribbon cable attached to the headphone jack.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 4

Letzte 30 Tage: 10

Insgesamt: 817