Einleitung
Prerequisite guide only! This guide shows how to remove the loudspeaker module.
Was du brauchst
-
-
Use the point of a spudger to lift and disconnect the antenna cable from the bottom end of the logic board.
-
-
-
Use the point of a spudger to lift up and disconnect the Lightning connector ribbon cable from its socket on the logic board.
-
-
-
-
Use the point of a spudger to lift and disconnect the antenna cable from its socket near the top of the logic board.
-
-
-
Carefully lift the antenna cable and de-route it from the edge of the phone. Use the point of a spudger to help lift the cable to free it from the retaining clips.
-
-
-
Remove the following Phillips screws securing the speaker to the rear case:
-
Two 2.6 mm screws
-
One 2.3 mm screw
-
One 2.3 mm screw
-
One 3.0 mm screw
-
-
-
Insert the flat end of a spudger between the long edge of the speaker module and the case wall.
-
Pry gently to loosen the speaker module.
-
Once the module is loose, lift and remove the speaker module from the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.