Zum Hauptinhalt wechseln

Einleitung

No audio? Replace the headphone jack!

  1. Before opening your iPod, ensure that the hold switch is in the locked position.  The orange bar should be visible, indicating hold is active.
    • Before opening your iPod, ensure that the hold switch is in the locked position. The orange bar should be visible, indicating hold is active.

  2. Insert an opening pick as far as possible into the seam between the plastic front and the metal rear panel, on the right edge of the iPod. You may need to rock the pick back and forth to slide it in farther. Use the opening pick to pry up against the plastic front panel and release five retaining tabs (seen in the third photo).
    • Insert an opening pick as far as possible into the seam between the plastic front and the metal rear panel, on the right edge of the iPod.

    • You may need to rock the pick back and forth to slide it in farther.

    • Use the opening pick to pry up against the plastic front panel and release five retaining tabs (seen in the third photo).

    • Slide the pick along the edge of the iPod and continue prying to release the rest of the retaining tabs.

    • After all five tabs along the right side are free, the case should easily open.

  3. The iPod case is now open, but don't separate the two halves just yet. There is still an orange ribbon cable connecting the headphone jack to the logic board.
    • The iPod case is now open, but don't separate the two halves just yet. There is still an orange ribbon cable connecting the headphone jack to the logic board.

    • Open the case like a book with the dock connector edge at the top, and lay the rear panel next to the front half of the iPod.

  4. Use a plastic tool or your fingernails to carefully disconnect the orange headphone jack cable. Be sure to pull  straight up on the connector, not the cable itself.
    • Use a plastic tool or your fingernails to carefully disconnect the orange headphone jack cable. Be sure to pull straight up on the connector, not the cable itself.

  5. Remove the 2 silver T6 Torx screws from the headphone jack.
    • Remove the 2 silver T6 Torx screws from the headphone jack.

  6. Grasp the headphone jack board and lift it out of the iPod.
    • Grasp the headphone jack board and lift it out of the iPod.

  7. Turn the headphone jack board over.
    • Turn the headphone jack board over.

    • Use the tip of your finger or a spudger to carefully flip up the black connector holding the headphone jack cable connector in place.

  8. Pull the orange headphone jack cable directly out of its connector.
    • Pull the orange headphone jack cable directly out of its connector.

Abschluss

To reassemble your device, follow these instructions in reverse order.

16 weitere Nutzer haben diese Anleitung absolviert.

iRobot

Mitglied seit: 24.09.2009

1 Reputation

624 Anleitungen geschrieben

How do you add a "confirmed success"? This worked perfectly for me. Thanks iRobot!

I agree that these pry tools pretty low quality. They did work faster than the guitar picks I've used in the past, but the material is just not durable. They were pretty much destroyed after one case opening.

anja - Antwort

The instructions are great, however when you ask about spares required there is no mention of the ribbon cable I require, just the board assembly!

Chris Stockley - Antwort

Hi

Where can I buy these components?

Thanks

Pablo Carter - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 3

Letzte 7 Tage: 7

Letzte 30 Tage: 33

Insgesamt: 21,563