iPod Shuffle 4. Generation Rückabdeckung tauschen

Einleitung

Für Reparaturen im Inneren des iPod Shuffle muss die Rückabdeckung abgenommen werden.

Was du brauchst

Schritt 1 Rückabdeckung

iPod Shuffle 4. Generation Rückabdeckung tauschen, Rückabdeckung: Schritt 1, Bild 1 von 1

Es ist sehr schwer in das Innere des Shuffles der 4.Generation zu gelangen, weil die Rücksabdeckung sowohl mit der Vorderseite verklebt ist als auch mit Metallklammern gehalten wird. Es ist kaum zu erwarten, dass du die Rückabdeckung des Shuffles ohne Schäden öffnen kannst.
Schalte deinen Shuffle aus, bevor du fortfährst.

Übersetzen

Schritt 2

Benutze iPod Öffnungswerkzeuge und Metallspatel, um die Rückabdeckung vom Shuffle abzuhebeln. Fange an der Naht in der Nähe des ON/OFF-Schalters an.

Übersetzen

I managed to open mine using no tools at all so without damage. Maybe the glue also weakened over time so might need to use some heat. I didn’t but then again it’s a second hand, old device in my case.

I used the clip on the back as a leverage to (ever so slightly) bend the back piece in the center. Having that bend is enough for the very small clips on the power switch side to detach. Once that side is removed you can slide the complete back out towards the direction of the power switch. I checked on a flat surface and the piece isn’t damaged, still straight. Just don’t keep it bend too long and don’t over bend it. It really shouldn’t take much since those notches are really small.

To close it again just slide the back side in again and then snap the power switch side back in place by lightly pressing it on top. Since the clips aren’t damaged this way it will close up nicely. If the notches got damaged you’ll have to use glue instead (hot glue will do and is easily removable again).

Ha ns - 20. Mär 2020 Antwort

what do you mean by bend the back piece in the center?! How do you do that exactly? Did you stick something in between the back piece and the clip and press in?

Jackson Chan - 6. Mai 2021 Antwort

I completely agree with Ha ns' comment. I really cannot understand how the author managed to open this device as described. There must be something like a 0.1mm gap between the housing and the cover, impossible to enter a spudger or pry tool. Use a lever on the hinged side of the clip to lift the cover, insert a 0.2mm plastic film or a thin plectrum or spudger on the bent center of the cover. Avoid to push the spudger down, as there are electronic components underneath, only lift the cover, without overbending. Move over to the side of the on/off switch, and release the 3 clips. On the other end an 8mm long nose will avoid lifting off the cover. You will have to slide it out horizontally. Clearly: you have to be very very careful and gifted...

cloclolulu - 5. Apr 2022 Antwort