Einleitung

This is an easy guide. It should only take a few minutes to complete. The only tool required is Phillips #1 Screwdriver.

Ersatzteile

Kein Ersatzteil erforderlich.

Lay the Roomba upside down on a flat surface. The edge brush is located near the battery pack.
  • Lay the Roomba upside down on a flat surface.

  • The edge brush is located near the battery pack.

Kommentar hinzufügen

Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.
  • Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.

Kommentar hinzufügen

Grab the edge brush and lift it up to remove.
  • Grab the edge brush and lift it up to remove.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Samantha Barrett

Mitglied seit 13.01.2014

501 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 17-5, Forte Winter 2014 Mitglied von Cal Poly, Team 17-5, Forte Winter 2014

CPSU-FORTE-W14S17G5

5 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 301