Zum Hauptinhalt wechseln

iRobot Roomba 655 Pet Series Front Bumper Replacement

Was du brauchst

  1. iRobot Roomba 655 Pet Series Front Bumper  Replacement, Front Bumper: Schritt 1, Bild 1 von 2 iRobot Roomba 655 Pet Series Front Bumper  Replacement, Front Bumper: Schritt 1, Bild 2 von 2
    • Remove the ten 11mm screws that hold the front bumper to the plastic bumper protector with your Phillips #1 screwdriver.

    • Pull the plastic bumper protector up and off of the bumper.

  2. iRobot Roomba 655 Pet Series Front Bumper  Replacement: Schritt 2, Bild 1 von 3 iRobot Roomba 655 Pet Series Front Bumper  Replacement: Schritt 2, Bild 2 von 3 iRobot Roomba 655 Pet Series Front Bumper  Replacement: Schritt 2, Bild 3 von 3
    • Flip the Roomba back over, so you are viewing the top.

    • Pull up on the front bumper to remove it.

    • Be careful not to pull too hard because there is wiring attached to the bumper.

    • Remove the two 7mm screws with your Phillips #1 screwdriver, holding the wire sensors in place to the front bumper.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Rhett

Mitglied seit: 01/22/15

1.329 Reputation

7 Anleitungen geschrieben

Team

Cal Poly, Team 21-20, Maness Winter 2015 Mitglied von Cal Poly, Team 21-20, Maness Winter 2015

CPSU-MANESS-W15S21G20

4 Mitglieder

14 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 4,287