Zum Hauptinhalt wechseln
Hilfe

iPhone 8 Plus Display Assembly Replacement

Nicht eigenständige Anleitung

Nicht eigenständige Anleitung

Bitte beachte, dass diese Anleitung nur eine grundständige Anleitung für andere Anleitungen ist.

Prerequisite-only guide for detaching the display assembly.

  • Autor: Jeff Suovanen
  • Geschätzte Zeit: 30 - 45 Minuten
  • Schwierigkeitsgrad: Moderat

Prerequisite-only guide for detaching the display assembly from the iPhone 8 Plus.

Schritt 1 Display Assembly  ¶ 

Use the tip of a spudger or a fingernail to disconnect the large lower display connector by prying it straight up from its socket. To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

Schritt 1 Display Assembly  ¶ 

  • Use the tip of a spudger or a fingernail to disconnect the large lower display connector by prying it straight up from its socket.

  • To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

Schritt 2  ¶ 

Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step. Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step.

Schritt 2  ¶ 

  • Disconnect the second lower display cable connector, directly behind the one you disconnected in the previous step.

Schritt 3  ¶ 

Remove the two tri-point Y000 screws securing the bracket over the front panel sensor assembly connector: One 1.0 mm screw

Schritt 3  ¶ 

  • Remove the two tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:

  • One 1.0 mm screw

  • One 1.2 mm screw

Schritt 4  ¶ 

Remove the bracket covering the front panel sensor assembly connector.

Schritt 4  ¶ 

  • Remove the bracket covering the front panel sensor assembly connector.

Schritt 5  ¶ 

Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket. Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket.

Schritt 5  ¶ 

  • Use the tip of a spudger or a fingernail to disconnect the front panel sensor assembly connector from its socket.

Schritt 6  ¶ 

Remove the display assembly.

Schritt 6  ¶