Zum Hauptinhalt wechseln
Hilfe

Aquaris M5 Display Replacement

This guide shows you how to replace a broken or malfunctioning display of your bq Aquaris M5.

  • Autor: Theo Mat
  • Geschätzte Zeit: 1 - 2 Stunden
  • Schwierigkeitsgrad: Schwierig

Use this guide to replace the display of your bq Aquaris M5.

Abschnitte
Werkzeuge

Schritt 1 Display  ¶ 

Use the flat end of a spudger to disconnect the displays flex cable from the mainboard.

Schritt 1 Display  ¶ 

  • Use the flat end of a spudger to disconnect the displays flex cable from the mainboard.

Schritt 2  ¶ 

Use an iOpener to loosen the displays adhesive.

Schritt 2  ¶ 

  • Use an iOpener to loosen the displays adhesive.

  • If you have never used an iOpener before, visit our iOpener Instruction Guide.

Schritt 3  ¶ 

Place a suction cup on the bottom-middle part of the screen and lift it up. Insert the tip of an opening pick in the gap between the display and the midframe. Slide the opening pick along the edge of the display to cut the adhesive.

Schritt 3  ¶ 

  • Place a suction cup on the bottom-middle part of the screen and lift it up.

  • Insert the tip of an opening pick in the gap between the display and the midframe.

  • Slide the opening pick along the edge of the display to cut the adhesive.

  • Move the opening pick around the top right corner and leave it there.

Schritt 4  ¶ 

Insert the tip of another opening pick next to the other one and slide it along the top side of your phone and around the top left corner, where you leave it. If the glue is hard to loosen, reheat it with your iOpener.

Schritt 4  ¶ 

  • Insert the tip of another opening pick next to the other one and slide it along the top side of your phone and around the top left corner, where you leave it.

  • If the glue is hard to loosen, reheat it with your iOpener.

Schritt 5  ¶ 

Take a third opening pick and insert the tip into the gap on the left side of the phone. Slide the opening pick down to the bottom of the phone.

Schritt 5  ¶ 

  • Take a third opening pick and insert the tip into the gap on the left side of the phone.

  • Slide the opening pick down to the bottom of the phone.

Schritt 6  ¶ 

Grasp the midframe of the phone with one hand and gently but steadily pull up the display to separate the adhesive of the lower part. Pull the display away from the midframe, while moving the flex cable through the opening in the mid frame. Pull the display away from the midframe, while moving the flex cable through the opening in the mid frame.

Schritt 6  ¶ 

  • Grasp the midframe of the phone with one hand and gently but steadily pull up the display to separate the adhesive of the lower part.

  • Pull the display away from the midframe, while moving the flex cable through the opening in the mid frame.