Zum Hauptinhalt wechseln
Hilfe

Dell Alienware 13 R3 Base Cover Replacement

Anleitung eines Mitglieds

Anleitung eines Mitglieds

Ein großartiges Mitglied unserer Community hat diese Anleitung erstellt. Sie wird nicht von iFixit Mitarbeitern überprüft.

In this guide, we will show how to remove and replace the Base Cover.

  • Autor: Terrence15
  • Geschätzte Zeit: 4 - 20 Minuten
  • Schwierigkeitsgrad: Einfach

In this guide, we will show how to remove and replace the Base Cover.

Schritt 1 Loosen the Screws  ¶ 

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

Schritt 1 Loosen the Screws  ¶ 

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • Loosen the five captive screws that secure the base cover to the computer base.

Schritt 2 Pry the Base Cover  ¶ 

Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Schritt 2 Pry the Base Cover  ¶ 

  • Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Schritt 3 Lift the Base Cover  ¶ 

Lift the base cover off the computer base.

Schritt 3 Lift the Base Cover  ¶ 

  • Lift the base cover off the computer base.

Schritt 4 Disconnect the Battery Cable  ¶ 

Using a plastic scribe, disconnect the battery cable from the system board.

Schritt 4 Disconnect the Battery Cable  ¶ 

  • Using a plastic scribe, disconnect the battery cable from the system board.

Schritt 5 Press and Hold the Power-Button  ¶ 

Kein Bild

Schritt 5 Press and Hold the Power-Button  ¶ 

  • Press and hold the power button for five seconds to ground the system board.

Schritt 6 Connect the Battery Cable  ¶ 

Kein Bild

Schritt 6 Connect the Battery Cable  ¶ 

  • Connect the battery cable to the system board.

Schritt 7 Slide the Tabs  ¶ 

Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Schritt 7 Slide the Tabs  ¶ 

  • Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Schritt 8 Tighten the Five Captive Screws  ¶ 

Tighten the five captive screws that secure the base cover to the computer base.

Schritt 8 Tighten the Five Captive Screws  ¶ 

  • Tighten the five captive screws that secure the base cover to the computer base.