Zum Hauptinhalt wechseln
Hilfe

Hoover LiNX The Nozzle Prongs Replacement

Replace broken or bent nozzle prongs in the Hoover LiNX.

  • Autor: Sara Vlhova
  • Geschätzte Zeit: 10 Minuten
  • Schwierigkeitsgrad: Einfach

This guide will show you how to replace the nozzle prongs in the motor in the nozzle. This guide would be needed if the prongs on your device are bent out of shape or if they are not transmitting power to the brush roll motor. Remember to remove thee battery from the device before starting this guide.

Schritt 1 The Nozzle Prongs  ¶ 

Remove the two 7.5mm Phillips #1 screws from the main body.

Schritt 1 The Nozzle Prongs  ¶ 

  • Remove the two 7.5mm Phillips #1 screws from the main body.

Schritt 2  ¶ 

Remove the black covering from the air tube.

Schritt 2  ¶ 

  • Remove the black covering from the air tube.

Schritt 3  ¶ 

Slide the prongs out through their channels.

Schritt 3  ¶ 

  • Slide the prongs out through their channels.

Schritt 4  ¶ 

Remove the angled neck and feed the prongs out through their channels. Remove the angled neck and feed the prongs out through their channels.

Schritt 4  ¶ 

  • Remove the angled neck and feed the prongs out through their channels.

Schritt 5  ¶ 

Replace the prongs. Replace the prongs.

Schritt 5  ¶ 

  • Replace the prongs.