Zum Hauptinhalt wechseln
Hilfe

PowerBook G4 Aluminum 17" 1.67 GHz (High-Res) Lower Case Replacement

Replacing your lower case requires removing nearly every component from your PowerBook.

Abschnitte
Dateien

Schritt 1 Lower Case  ¶ 

Remove the following four screws: Three 11.1 mm T8 Torx.

Schritt 1 Lower Case  ¶ 

  • Remove the following four screws:

  • Three 11.1 mm T8 Torx.

  • One 3.9 mm T8 Torx.

  • Lift the hard drive out of the lower case.

Schritt 2  ¶ 

Remove the two T8 Torx screws securing the sound card to the lower case.

Schritt 2  ¶ 

  • Remove the two T8 Torx screws securing the sound card to the lower case.

Schritt 3  ¶ 

Use the flat end of a spudger to pry the USB sockets away from the left edge of the lower case.

Schritt 3  ¶ 

  • Use the flat end of a spudger to pry the USB sockets away from the left edge of the lower case.

Schritt 4  ¶ 

Lift the sound card slightly out of the lower case, minding the fragile lower portion holding the microphone connector. The sound card is still attached to the PowerBook by the microphone cable.

Schritt 4  ¶ 

  • Lift the sound card slightly out of the lower case, minding the fragile lower portion holding the microphone connector.

  • The sound card is still attached to the PowerBook by the microphone cable.

Schritt 5  ¶ 

Pull the sound card ribbon cable straight away from its socket on the sound card.

Schritt 5  ¶ 

  • Pull the sound card ribbon cable straight away from its socket on the sound card.

Schritt 6  ¶ 

Use your fingernails to pull the microphone connector straight away from its socket on the sound card.

Schritt 6  ¶ 

  • Use your fingernails to pull the microphone connector straight away from its socket on the sound card.

Schritt 7  ¶ 

Remove the two T8 Torx screws securing the PRAM battery & USB board to the lower case.

Schritt 7  ¶ 

  • Remove the two T8 Torx screws securing the PRAM battery & USB board to the lower case.

Schritt 8  ¶ 

Pull the board away from the side of the lower case to separate the USB socket from the bezel on the lower case. Lift the PRAM battery & USB board out of the lower case.

Schritt 8  ¶ 

  • Pull the board away from the side of the lower case to separate the USB socket from the bezel on the lower case.

  • Lift the PRAM battery & USB board out of the lower case.

Schritt 9  ¶ 

If necessary, remove the strip of yellow kapton tape covering the battery connector.

Schritt 9  ¶ 

  • If necessary, remove the strip of yellow kapton tape covering the battery connector.

Schritt 10  ¶ 

Remove the two 8.5 mm T8 Torx screws securing the battery connector to the lower case.

Schritt 10  ¶ 

  • Remove the two 8.5 mm T8 Torx screws securing the battery connector to the lower case.

Schritt 11  ¶ 

Pull the battery connector out of its opening in the lower case.

Schritt 11  ¶ 

  • Pull the battery connector out of its opening in the lower case.

  • Lower case remains.