Zum Hauptinhalt wechseln
Hilfe

Lorex A-MPX IR Bullet Camera Disassembly

Anleitung eines Mitglieds

Anleitung eines Mitglieds

Ein großartiges Mitglied unserer Community hat diese Anleitung erstellt. Sie wird nicht von iFixit Mitarbeitern überprüft.

A quick look inside once of the newest LOREX by FLIR security surveillance camera.

  • Autor: Hans
  • Schwierigkeitsgrad: Moderat

Schritt 1 Quick look  ¶ 

This little camera comes with the LHA4000 kit by Lorex. It has a 4K sensor with motion sensor and infrared lights

Schritt 1 Quick look  ¶ 

  • This little camera comes with the LHA4000 kit by Lorex.

  • It has a 4K sensor with motion sensor and infrared lights

Schritt 2 Removing the lense  ¶ 

Remove the 4 screws holding down the camera lens. They are standard Philipps #1 Be careful not to pull the sensor as it is still attached to the signal cables.

Schritt 2 Removing the lense  ¶ 

  • Remove the 4 screws holding down the camera lens. They are standard Philipps #1

  • Be careful not to pull the sensor as it is still attached to the signal cables.

Schritt 3 Camera Sensor  ¶ 

The system board is directly attached to the back of the lens. The connector is a simple 4 wires. This make it very easy to repair. The connector is a simple 4 wires. This make it very easy to repair.

Schritt 3 Camera Sensor  ¶ 

  • The system board is directly attached to the back of the lens.

  • The connector is a simple 4 wires. This make it very easy to repair.

Schritt 4 Outer casing  ¶ 

There is a rubber grommet that keep moisture away from the inside of the board. There IS also this sillica pack inside the camera if moisture ever breach in. The base is fixed to the feet using a single Phillips #1 screw

Schritt 4 Outer casing  ¶ 

  • There is a rubber grommet that keep moisture away from the inside of the board.

  • There IS also this sillica pack inside the camera if moisture ever breach in.

  • The base is fixed to the feet using a single Phillips #1 screw

  • In order to separate the camera from the feet, you will need to undo the connector. The wires are thin so be careful.

Schritt 5 Whole assembly  ¶ 

Very simple design for a very simple device. The whole assembly is held by 6 screws. Making it very easy to re-assemble.

Schritt 5 Whole assembly  ¶ 

  • Very simple design for a very simple device. The whole assembly is held by 6 screws. Making it very easy to re-assemble.