Zum Hauptinhalt wechseln
Hilfe

Technik: Repairing Bose On-Ear headphones Shorted Right earphone

Action Shots

Action Shots

Sei ein Actionheld! Diese Anleitung benötigt Bilder, damit besser veranschaulicht werden kann, wie bestimmte Handgriffe ausgeführt werden.

Benötigt Mehr Bilder

Benötigt Mehr Bilder

Einige Bilder mehr würden die Vorgehensweise in dieser Anleitung deutlich klarer machen.

Fehlende Schritte

Fehlende Schritte

Ups! In dieser Anleitung fehlen momentan einige wichtige Schritte.

Anleitung eines Mitglieds

Anleitung eines Mitglieds

Ein großartiges Mitglied unserer Community hat diese Anleitung erstellt. Sie wird nicht von iFixit Mitarbeitern überprüft.

The right earphone has a short within the headband

Schritt 1 Repairing Bose On-Ear headphones Shorted Right earphone  ¶ 

To repair a short in the wires, the head band has two screws, just above the headphones cups. To repair a short in the wires, the head band has two screws, just above the headphones cups.

Schritt 1 Repairing Bose On-Ear headphones Shorted Right earphone  ¶ 

  • To repair a short in the wires, the head band has two screws, just above the headphones cups.

Schritt 2  ¶ 

After removing the two small screws, try closing the headband to it's shortest position. The outer panel will pop out toward the bottom edge. You can then slide the panel out from under the collar. The collar may slide out of place while working, but can easily be slid back during re-assembly.

Schritt 2  ¶ 

  • After removing the two small screws, try closing the headband to it's shortest position. The outer panel will pop out toward the bottom edge.

  • You can then slide the panel out from under the collar. The collar may slide out of place while working, but can easily be slid back during re-assembly.

Schritt 3  ¶ 

After inspecting the wire inside, you may notice cracks in the corners were the wires bend when the headphones are folded. I cut  a thin strip of electrical tape to use as reinforcement. After sliding the collar up, you can extend the wire, giving you better access for wrapping or replacing.

Schritt 3  ¶ 

  • After inspecting the wire inside, you may notice cracks in the corners were the wires bend when the headphones are folded. I cut a thin strip of electrical tape to use as reinforcement.

  • After sliding the collar up, you can extend the wire, giving you better access for wrapping or replacing.