Zum Hauptinhalt wechseln
Hilfe

IBM ThinkPad T30 Keyboard Replacement

Aufzählungszeichen!

Aufzählungszeichen!

Ein verbesserter Einsatz von Markups und der Farbe bzw. Art von Aufzählungszeichen würde diese Anleitung verständlicher machen.

Fehler in den Markups

Fehler in den Markups

Diese Anleitung benötigt bessere Markups. Hilf aus, indem du sie korrigierst oder einige Markup-Anmerkungen erstellst.

Fehlende Schritte

Fehlende Schritte

Ups! In dieser Anleitung fehlen momentan einige wichtige Schritte.

A guide showing how to remove and replace the keyboard from the IBM ThinkPad T30.

  • Autor: Alex Kost
  • Geschätzte Zeit: 15 - 30 Minuten
  • Schwierigkeitsgrad: Moderat

Use this guide to replace your keyboard.

Schritt 1 Keyboard  ¶ 

Begin by removing the two black 16 mm Phillips #0 screws. The screws can be identified by the two notches next to each screw.  One (marked in red) is near the battery lock and the other (not pictured) is next to the Wi-Fi cover. Push up the bottom of the keyboard by poking your finger through the hole to the right of the yellow bios battery. You will feel slight resistance.

Schritt 1 Keyboard  ¶ 

  • Begin by removing the two black 16 mm Phillips #0 screws. The screws can be identified by the two notches next to each screw. One (marked in red) is near the battery lock and the other (not pictured) is next to the Wi-Fi cover.

  • Push up the bottom of the keyboard by poking your finger through the hole to the right of the yellow bios battery. You will feel slight resistance.

  • Be sure to not lift the keyboard too far. It is still attached to the computer with a ribbon connector.

Schritt 2  ¶ 

Lift the keyboard to expose the ribbon connector and lean it against the computer screen to keep the ribbon intact. If the ribbon is broken, the keyboard is permanently unusable and needs to be replaced Use the plastic opening tool to gently pry the connector up from the motherboard.

Schritt 2  ¶ 

  • Lift the keyboard to expose the ribbon connector and lean it against the computer screen to keep the ribbon intact.

  • If the ribbon is broken, the keyboard is permanently unusable and needs to be replaced

  • Use the plastic opening tool to gently pry the connector up from the motherboard.

  • You can now safely remove the keyboard.