Zum Hauptinhalt wechseln
Hilfe

iPod Touch 5th Generation Lightning Connector Assembly Replacement

Nicht eigenständige Anleitung

Nicht eigenständige Anleitung

Bitte beachte, dass diese Anleitung nur eine grundständige Anleitung für andere Anleitungen ist.

prerequisite

prerequisite

Schritt 1 Lightning Connector Assembly  ¶ 

Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.

Schritt 1 Lightning Connector Assembly  ¶ 

  • Use the tip of a spudger to peel back a small piece of tape covering a screw on the side of the headphone jack.

Schritt 2  ¶ 

Remove the following screws securing the headphone jack, Lightning connector, and speaker.

Schritt 2  ¶ 

  • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

  • Three 2.6 mm #000 Phillips screws

  • Two 2.0 mm #000 Phillips screws

Schritt 3  ¶ 

Use the flat end of a spudger to pry the speaker up from the rear case.

Schritt 3  ¶ 

  • Use the flat end of a spudger to pry the speaker up from the rear case.

  • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

Schritt 4  ¶ 

Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Schritt 4  ¶ 

  • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.