Zum Hauptinhalt wechseln
Hilfe

iPad ClamCase

Teardown

Teardown

Teardowns bieten einen Einblick in ein device und sollten nicht als Demontageanleitung verwendet werden.

Benötigt Bessere Bilder

Benötigt Bessere Bilder

Schönere Fotos werden diese Anleitung verbessern. Trage dazu bei, indem du die Alten bearbeitest oder Neue aufnimmst und hochlädst!

Anleitung eines Mitglieds

Anleitung eines Mitglieds

Ein großartiges Mitglied unserer Community hat diese Anleitung erstellt. Sie wird nicht von iFixit Mitarbeitern überprüft.

This is the teardown for a Clamcase for iPad 2.

Schritt 1 iPad ClamCase  ¶ 

You can skip the first 2 steps if you don't want to detach the upper and keyboard covers from each other. Open the case and unpeel the 2 black stickers in the top corners of the keyboard.

Schritt 1 iPad ClamCase  ¶ 

  • You can skip the first 2 steps if you don't want to detach the upper and keyboard covers from each other.

  • Open the case and unpeel the 2 black stickers in the top corners of the keyboard.

  • This will reveal the 6 screws that attach the upper cover to the keyboard cover.

Schritt 2  ¶ 

Use the T9 Torx screwdriver to unscrew the 2 bigger screws in the middle of each side. Use  the T6 Torx screwdriver to unscrew the remaining 4 screws.

Schritt 2  ¶ 

  • Use the T9 Torx screwdriver to unscrew the 2 bigger screws in the middle of each side.

  • Use the T6 Torx screwdriver to unscrew the remaining 4 screws.

Schritt 3  ¶ 

Turn the keyboard cover over so the bottom is facing up.  Manually remove the thin black covering that is attached to the bottom. Be patient, the thin black covering might be really stuck to the bottom.

Schritt 3  ¶ 

  • Turn the keyboard cover over so the bottom is facing up. Manually remove the thin black covering that is attached to the bottom.

  • Be patient, the thin black covering might be really stuck to the bottom.

Schritt 4  ¶ 

Once the thin black covering is removed, you will see 15 screws.

Schritt 4  ¶ 

  • Once the thin black covering is removed, you will see 15 screws.

  • Use the T6 Torx screwdriver to remove the screws.

Schritt 5  ¶ 

Once the screws are removed, lift off the bottom panel to access the keyboard and battery.

Schritt 5  ¶ 

  • Once the screws are removed, lift off the bottom panel to access the keyboard and battery.

Schritt 6  ¶ 

You are done.

Schritt 6  ¶ 

  • You are done.