Zum Hauptinhalt wechseln
Hilfe

HTC Droid Eris Midframe Replacement

Action Shots

Action Shots

Sei ein Actionheld! Diese Anleitung benötigt Bilder, damit besser veranschaulicht werden kann, wie bestimmte Handgriffe ausgeführt werden.

Unklarer Text

Unklarer Text

Teile des Textes dieser Anleitung sind verwirrend, doppelt oder vom Thema abweichend. Kläre das, indem du sie bearbeitest!

Teile und verbessere

Teile und verbessere

Die Schritte in dieser Anleitung sollten getrennt und in eine Abfolge von grundständigen Anleitungen umgeformt werden.

Use this guide to replace the HTC Droid Eris midframe.

This guide will teach you how to replace/install the midframe.

Abschnitte
Werkzeuge

Schritt 1 Midframe  ¶ 

At the lower right hand corner of the phone (as highlighted in the picture as shown) use one hand to hold the device in place and use your finger (on your free hand) to push the micro SD card inwards until you hear a "click" sound and it pops out. If that method is difficult, use the plastic opening tool to push the micro SD card inwards and it will make a "click" sound and pop out.

Schritt 1 Midframe  ¶ 

  • At the lower right hand corner of the phone (as highlighted in the picture as shown) use one hand to hold the device in place and use your finger (on your free hand) to push the micro SD card inwards until you hear a "click" sound and it pops out.

  • If that method is difficult, use the plastic opening tool to push the micro SD card inwards and it will make a "click" sound and pop out.

Schritt 2  ¶ 

Use the T-4 screwdriver to remove the three .050 mm screws from the back cover. Place the screws in a safe place. The screws are extremely small and easy to lose. You will need to use the screws in order to put the device back together again.

Schritt 2  ¶ 

  • Use the T-4 screwdriver to remove the three .050 mm screws from the back cover.

  • Place the screws in a safe place. The screws are extremely small and easy to lose. You will need to use the screws in order to put the device back together again.

Schritt 3  ¶ 

Use the plastic opening tool and place it in the gap by the chrome bezels which are located on both sides of the device. Pull the plastic opening tool downward so that the plastic case will pry open. Start prying open the device and work clockwise. DON’T BREAK THE CLIPS  (you can damage the frame this way). Pry it gently until you hear it click and start to see it open.

Schritt 3  ¶ 

  • Use the plastic opening tool and place it in the gap by the chrome bezels which are located on both sides of the device. Pull the plastic opening tool downward so that the plastic case will pry open. Start prying open the device and work clockwise.

  • DON’T BREAK THE CLIPS (you can damage the frame this way). Pry it gently until you hear it click and start to see it open.

  • ''After the clips are disengaged, there are no cables holding the back panel in its place, you should be able to pull the midframe out easily..'