Zum Hauptinhalt wechseln
Hilfe

Teenage Engineering OP-1 Connector Board Replacement

Use this guide to replace the Connector Board of the OP-1, including the microphone, the line-in / line-out connectors and the USB port.

Use this guide to replace the Connector Board of the OP-1, including the microphone, the line-in / line-out connectors and the USB port.

Schritt 1 Remove Back Panel  ¶ 

Open the back panel by using a Jimmy on the side of the panel. Be careful not to damage the OP-1 coating. Lift the back panel and remove it. The Connector Board is revealed. Lift the back panel and remove it. The Connector Board is revealed.

Schritt 1 Remove Back Panel  ¶ 

  • Open the back panel by using a Jimmy on the side of the panel. Be careful not to damage the OP-1 coating.

  • Lift the back panel and remove it. The Connector Board is revealed.

Schritt 2 Remove Connector Board  ¶ 

Disconnect the flex connector by lifting it up with a spudger. Remove the three Phillips screws. Do not loose the washer at the bottom screw. Take out the connector board.

Schritt 2 Remove Connector Board  ¶ 

  • Disconnect the flex connector by lifting it up with a spudger.

  • Remove the three Phillips screws. Do not loose the washer at the bottom screw.

  • Take out the connector board.

  • Make sure to keep the black rubber pad underneath the board.

Schritt 3  ¶ 

Don't forget the cover for the on/off switch. Simply take it off from the old board and transfer it to the new board.

Schritt 3  ¶ 

  • Don't forget the cover for the on/off switch.

  • Simply take it off from the old board and transfer it to the new board.