Zum Hauptinhalt wechseln
Hilfe

Nokero N222-Huron Battery Replacement

Empfohlene Anleitung von Studenten

Empfohlene Anleitung von Studenten

Diese Anleitung ist das Werk unserer herausragenden Studenten und wird von den iFixit-Mitarbeitern als außergewöhnlich gut eingestuft.

Empfohlene Anleitung

Empfohlene Anleitung

Diese Anleitung wird von den iFixit-Mitarbeitern als außergewöhnlich gut eingestuft.

Replace the battery when the device stops holding a charge

  • Autor: Vinny Capone
  • Geschätzte Zeit: 20 Minuten
  • Schwierigkeitsgrad: Moderat

After a certain number of cycles, batteries begin to stop holding their charge. Follow this guide to bring new life to your trusty Nokero N222-Huron.

Abschnitte
Werkzeuge
Relevante Ersatzteile

Schritt 1 Battery  ¶ 

Remove the two #1 Phillips screws hidden underneath stickers on the face of the device. Use a plastic spudger to carefully peel back the metallic sticker that reads, “Warranty Void if Removed” and the Nokero sticker as shown in the picture. In case there was any question, removing this sticker and taking your device apart will void the warranty In case there was any question, removing this sticker and taking your device apart will void the warranty

Schritt 1 Battery  ¶ 

  • Remove the two #1 Phillips screws hidden underneath stickers on the face of the device. Use a plastic spudger to carefully peel back the metallic sticker that reads, “Warranty Void if Removed” and the Nokero sticker as shown in the picture.

  • In case there was any question, removing this sticker and taking your device apart will void the warranty

Schritt 2  ¶ 

Carefully separate the two halves of the device. You will notice a red and a black wire connecting the solar panel to the circuit board. Set the device as shown to keep the wires relaxed. If the halves of the device are separated too quickly, it is possible for the wires to be strained or to come loose from the circuit board. If this happens, the wires will need to be resoldered to the board.

Schritt 2  ¶ 

  • Carefully separate the two halves of the device. You will notice a red and a black wire connecting the solar panel to the circuit board. Set the device as shown to keep the wires relaxed.

  • If the halves of the device are separated too quickly, it is possible for the wires to be strained or to come loose from the circuit board. If this happens, the wires will need to be resoldered to the board.

Schritt 3  ¶ 

Remove the battery from the clips and set aside

Schritt 3  ¶ 

  • Remove the battery from the clips and set aside

  • The battery can be replaced by any 18650 battery found online, but the device battery is a 1400mAh, 3.2V battery. Keep in mind that the light will last longer with a higher mAh rated battery, but it will also take longer to fully charge, especially when using the solar panel.

Schritt 4  ¶ 

Be careful assembling the device to ensure that the wires do not get caught. Make sure that the switch is lined up with the rubber button and that the screws are lined up with the stand-offs.

Schritt 4  ¶ 

  • Be careful assembling the device to ensure that the wires do not get caught. Make sure that the switch is lined up with the rubber button and that the screws are lined up with the stand-offs.