Zum Hauptinhalt wechseln
Hilfe

Disassembling Kodak Easyshare C813 Back Cover

  • Autor: Susan Marano
  • Geschätzte Zeit: 5 - 10 Minuten
  • Schwierigkeitsgrad: Einfach

This tutorial demonstrates how to remove the back cover from the camera

Schritt 1 Back Cover  ¶ 

Before removing back cover, it is advisable to use an anti-static wrist strap to prevent damage to electronics.

Schritt 1 Back Cover  ¶ 

Schritt 2  ¶ 

Turn the camera off by firmly pressing the power button located on top of the camera.

Schritt 2  ¶ 

  • Turn the camera off by firmly pressing the power button located on top of the camera.

Schritt 3  ¶ 

Locate the 7 screws holding the back cover on. Three screws are located on the bottom of the camera. Two screws are located on the side shown in the photograph.

Schritt 3  ¶ 

  • Locate the 7 screws holding the back cover on.

  • Three screws are located on the bottom of the camera.

  • Two screws are located on the side shown in the photograph.

  • Two final screws are located on the opposite side shown in the photograph.

Schritt 4  ¶ 

Remove all 7 screws: Hold the camera firmly with one hand so that you can still see a screw. Place the Philips 00(Found here)screwdriver into the screw.

Schritt 4  ¶ 

  • Remove all 7 screws:

  • Hold the camera firmly with one hand so that you can still see a screw.

  • Place the Philips 00(Found here)screwdriver into the screw.

  • Turn the screwdriver to the left until it is free.

  • Repeat for the remaining screws.

Schritt 5  ¶ 

Use plastic opening tools to slightly open the side of the case. Insert a plastic opening tool and apply pressure to the internal three tabs at the top. The first two are near the words "3X Optical Zoom".

Schritt 5  ¶ 

  • Use plastic opening tools to slightly open the side of the case.

  • Insert a plastic opening tool and apply pressure to the internal three tabs at the top.

  • The first two are near the words "3X Optical Zoom".

  • The third is near the shutter button.

Schritt 6  ¶ 

Gently pull apart the back cover from the rest of the camera. Make sure there are no more screws or tabs keeping the cover on. Use the plastic opening tool to separate any sides still closely connected.

Schritt 6  ¶ 

  • Gently pull apart the back cover from the rest of the camera.

  • Make sure there are no more screws or tabs keeping the cover on.

  • Use the plastic opening tool to separate any sides still closely connected.