Zum Hauptinhalt wechseln
Hilfe

HP Pavilion DV1000 Screen Replacement

Benötigt Bessere Bilder

Benötigt Bessere Bilder

Schönere Fotos werden diese Anleitung verbessern. Trage dazu bei, indem du die Alten bearbeitest oder Neue aufnimmst und hochlädst!

Action Shots

Action Shots

Sei ein Actionheld! Diese Anleitung benötigt Bilder, damit besser veranschaulicht werden kann, wie bestimmte Handgriffe ausgeführt werden.

Fehlende Schritte

Fehlende Schritte

Ups! In dieser Anleitung fehlen momentan einige wichtige Schritte.

Schritt Trimmer

Schritt Trimmer

Diese Anleitung enthält unnötige Schritte. Kürze sie heraus, damit sie präziser wird!

Fehler in den Markups

Fehler in den Markups

Diese Anleitung benötigt bessere Markups. Hilf aus, indem du sie korrigierst oder einige Markup-Anmerkungen erstellst.

This guide will give step-by-step instructions on how to replace the screen on an HP Pavilion dv1000.

  • Autor: Tyler Latour
  • Geschätzte Zeit: 30 Minuten
  • Schwierigkeitsgrad: Moderat
Abschnitte

Schritt 1 Screen  ¶ 

Remove the rubber inserts with the spudger.

Schritt 1 Screen  ¶ 

  • Remove the rubber inserts with the spudger.

  • Note: When reassembling, notice that the two lower rubber pieces are flatter than the four rubber pieces located at the top of the screen.

  • Remove the screws behind the rubber inserts.

Schritt 2  ¶ 

Carefully pry loose the screen casing with a plastic prying tool. Carefully pry loose the screen casing with a plastic prying tool.

Schritt 2  ¶ 

  • Carefully pry loose the screen casing with a plastic prying tool.

Schritt 3  ¶ 

Remove the plug by prying it loose with the spudger. Pulling the plug with your fingers could be potentially dangerous unless you are wearing work gloves.

Schritt 3  ¶ 

  • Remove the plug by prying it loose with the spudger.

  • Pulling the plug with your fingers could be potentially dangerous unless you are wearing work gloves.

Schritt 4  ¶ 

Remove the single screw marked in the image.

Schritt 4  ¶ 

  • Remove the single screw marked in the image.

  • Be careful not to break the clips or pull any wires.

Schritt 5  ¶ 

Remove the 4 screws marked in the picture. Support the back cover and set it down on the desk. Do not pull off the back cover. Support the back cover and set it down on the desk. Do not pull off the back cover.

Schritt 5  ¶ 

  • Remove the 4 screws marked in the picture.

  • Support the back cover and set it down on the desk. Do not pull off the back cover.

Schritt 6  ¶ 

Remove the screws on each side of the screen. There are four screws on each side. Remove the screen.

Schritt 6  ¶ 

  • Remove the screws on each side of the screen. There are four screws on each side.

  • Remove the screen.