Zum Hauptinhalt wechseln
Hilfe

MacBook Pro 13" Retina Display Late 2013 Heat Sink Replacement

Replace the Heat Sink in your MacBook Pro 13" Retina Display Late 2013.

Use this guide to remove or replace the heat sink.

Don't forget to follow our thermal paste application guide after you have removed your heat sink.

Schritt 1 Heat Sink  ¶ 

Carefully remove the rubber fan bumper from the edge of the heat sink. The fan bumper wraps around the heat sink and fits into slots in the fan duct. During reassembly, be sure to fit the tabs into the notches in the fan duct. The fan bumper wraps around the heat sink and fits into slots in the fan duct. During reassembly, be sure to fit the tabs into the notches in the fan duct.

Schritt 1 Heat Sink  ¶ 

  • Carefully remove the rubber fan bumper from the edge of the heat sink.

  • The fan bumper wraps around the heat sink and fits into slots in the fan duct. During reassembly, be sure to fit the tabs into the notches in the fan duct.

Schritt 2  ¶ 

Use the flat end of a spudger to peel the four foam stickers off of the heat sink screws. Use the flat end of a spudger to peel the four foam stickers off of the heat sink screws.

Schritt 2  ¶ 

  • Use the flat end of a spudger to peel the four foam stickers off of the heat sink screws.

Schritt 3  ¶ 

Remove the following screws securing the heat sink to the logic board:

Schritt 3  ¶ 

  • Remove the following screws securing the heat sink to the logic board:

  • Four 2.6 mm T5 screws

  • One 2.4 mm Phillips #000 screw

Schritt 4  ¶ 

Remove the heat sink from the laptop. When reassembling your computer, follow our thermal paste application guide to reapply the thermal paste.

Schritt 4  ¶