Zum Hauptinhalt wechseln
Hilfe

Canon EOS 5D Mark II Front Panel Replacement

This guide consists of removing the front panel.

  • Autor: Mike Seed
  • Geschätzte Zeit: 10 - 25 Minuten
  • Schwierigkeitsgrad: Moderat

This guide will show users how to remove the front panel. It is necessary to remove the front panel in order to remove the top panel and access many internal components.

Abschnitte
Werkzeuge

Schritt 1 Front Panel  ¶ 

Using tweezers, pull out the wire attaching the front panel to the motherboard.

Schritt 1 Front Panel  ¶ 

  • Using tweezers, pull out the wire attaching the front panel to the motherboard.

Schritt 2  ¶ 

Peel off the rubber cover on the front panel in order to access the screws underneath.

Schritt 2  ¶ 

  • Peel off the rubber cover on the front panel in order to access the screws underneath.

Schritt 3  ¶ 

Remove each of the 4.9 mm three screws using a Phillips #0.

Schritt 3  ¶ 

  • Remove each of the 4.9 mm three screws using a Phillips #0.

Schritt 4  ¶ 

Remove the two 4.8 mm screws above where the lens would be using a Phillips #0.

Schritt 4  ¶ 

  • Remove the two 4.8 mm screws above where the lens would be using a Phillips #0.

Schritt 5  ¶ 

Remove the single screw underneath where the lens would be using a Phillips #0.

Schritt 5  ¶ 

  • Remove the single screw underneath where the lens would be using a Phillips #0.

Schritt 6  ¶ 

Remove the four 3.0 mm screws next to the memory card reader using a Phillips #0. Remove the four 3.0 mm screws next to the memory card reader using a Phillips #0. Remove the four 3.0 mm screws next to the memory card reader using a Phillips #0.

Schritt 6  ¶ 

  • Remove the four 3.0 mm screws next to the memory card reader using a Phillips #0.

Schritt 7  ¶ 

Remove the front panel by lifting upwards from the right side where the in/out ports used to be. Remove the front panel by lifting upwards from the right side where the in/out ports used to be.

Schritt 7  ¶ 

  • Remove the front panel by lifting upwards from the right side where the in/out ports used to be.