Zum Hauptinhalt wechseln
Hilfe

MacBook Pro 17" Unibody Logic Board Replacement

Completely replace the logic board on your MacBook Pro 17" Unibody.

  • Autor: Andrew Bookholt
  • Geschätzte Zeit: 1 - 2 Stunden
  • Schwierigkeitsgrad: Schwierig

Use this guide to replace your MacBook Pro's logic board. Before reattaching the heat sink, it is essential to apply a new layer of thermal paste.

Schritt 1 Logic Board  ¶ 

Pull the DC-In board connector out of its socket on the logic board.

Schritt 1 Logic Board  ¶ 

  • Pull the DC-In board connector out of its socket on the logic board.

  • Pull the cables parallel to the face of the logic board toward the heat sink.

Schritt 2  ¶ 

Remove the two 7.9 mm Phillips screws securing the left speaker to the logic board.

Schritt 2  ¶ 

  • Remove the two 7.9 mm Phillips screws securing the left speaker to the logic board.

Schritt 3  ¶ 

Slightly lift the left speaker assembly away from the logic board. Use the flat end of a spudger to lift the left speaker and microphone connectors out of their sockets on the logic board.

Schritt 3  ¶ 

  • Slightly lift the left speaker assembly away from the logic board.

  • Use the flat end of a spudger to lift the left speaker and microphone connectors out of their sockets on the logic board.

Schritt 4  ¶ 

Release the tabs on each side of the RAM chip by simultaneously pushing each tab away from the RAM. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

Schritt 4  ¶ 

  • Release the tabs on each side of the RAM chip by simultaneously pushing each tab away from the RAM.

  • These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  • After the RAM chip has popped up, pull it straight out of its socket.

  • Repeat this process if a second RAM chip is installed.

  • Logic board remains.