Zum Hauptinhalt wechseln
Hilfe

ComNet Ericsson Panther 600P Speaker Replacement

This guide will show you how to remove the speaker from the ComNet Ericsson Panther 600P.

  • Autor: Kellan Sells
  • Geschätzte Zeit: 5 - 10 Minuten
  • Schwierigkeitsgrad: Einfach

Speakers will sometimes rupture from extended periods of high volume. Speakers may also malfunction due to old age. Without a speaker, many devices can not be used. This guide helps you replace the speakers for the ComNet Ericsson Panther 600P.

Abschnitte
Werkzeuge

Schritt 1 Speaker  ¶ 

Locate the device's speaker inside the front panel of the exterior case. Locate the display and speaker stabilizer.

Schritt 1 Speaker  ¶ 

  • Locate the device's speaker inside the front panel of the exterior case.

  • Locate the display and speaker stabilizer.

  • Lift the stabilizer up from the bottom and pull the stabilizer out of case.

Schritt 2  ¶ 

Locate the two 3.75mm screws holding the speaker to the exterior case. Using a T15 Torx screwdriver, unscrew the 3.75mm screws. Using a T15 Torx screwdriver, unscrew the 3.75mm screws.

Schritt 2  ¶ 

  • Locate the two 3.75mm screws holding the speaker to the exterior case.

  • Using a T15 Torx screwdriver, unscrew the 3.75mm screws.

Schritt 3  ¶ 

Lift up on the bottom of the speaker to detach the speaker. Pull the speaker out of the case.

Schritt 3  ¶ 

  • Lift up on the bottom of the speaker to detach the speaker.

  • Pull the speaker out of the case.