Zum Hauptinhalt wechseln
Hilfe

ComNet Ericsson Panther 600P Motherboard Replacement

This guide will show you how to access the motherboard of the ComNet Ericsson Panther 600P radio.

  • Autor: Tim Moreau
  • Geschätzte Zeit: 30 - 40 Minuten
  • Schwierigkeitsgrad: Moderat

If your device has received water damage or experienced a similarly devastating event, the motherboard may have become damaged or even destroyed.

This guide will take you through the necessary steps to access and replace the motherboard.

Abschnitte

Schritt 1 Antenna, Volume, Channel Nuts  ¶ 

Remove the rubber O-rings from the antenna jack, volume switch, and channel switch. Once the rubber O-rings have been removed, use small needle nose pliers to unscrew the nuts on the antenna jack, volume switch, and channel switch. There are washers underneath the nuts on the antenna jack, volume switch, and channel switch. Set these washers aside.

Schritt 1 Antenna, Volume, Channel Nuts  ¶ 

  • Remove the rubber O-rings from the antenna jack, volume switch, and channel switch.

  • Once the rubber O-rings have been removed, use small needle nose pliers to unscrew the nuts on the antenna jack, volume switch, and channel switch.

  • There are washers underneath the nuts on the antenna jack, volume switch, and channel switch. Set these washers aside.

Schritt 2  ¶ 

Using a T15 Torx screwdriver, unscrew the 3.8mm screw from the case.

Schritt 2  ¶ 

  • Using a T15 Torx screwdriver, unscrew the 3.8mm screw from the case.

Schritt 3 Internal Case - Back  ¶ 

Using any convenient hand-placement, pull the motherboard away from the case. The antenna jack, volume dial, and channel dial are attached to the motherboard. Be sure to pull the motherboard downward so they clear their respective slots in the case. Lift the motherboard completely free of the case.

Schritt 3 Internal Case - Back  ¶ 

  • Using any convenient hand-placement, pull the motherboard away from the case.

  • The antenna jack, volume dial, and channel dial are attached to the motherboard. Be sure to pull the motherboard downward so they clear their respective slots in the case.

  • Lift the motherboard completely free of the case.