Zum Hauptinhalt wechseln
Hilfe

Canon PowerShot S100 Outer Case Replacement

This guide is a prerequisite for other replacement and removal guides. The guide will demonstrate how to disassemble the plastic cover that protects the internal parts of the camera.

  • Autor: Ricky
  • Geschätzte Zeit: 10 Minuten
  • Schwierigkeitsgrad: Einfach

Removing the body cover is necessary to access other parts inside the camera.

Schritt 1 Outer Case  ¶ 

Remove the 2 screws (3.2mm, Phillips #00) found on the bottom side of the camera. Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera. Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera where the terminals are.

Schritt 1 Outer Case  ¶ 

  • Remove the 2 screws (3.2mm, Phillips #00) found on the bottom side of the camera.

  • Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera.

  • Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera where the terminals are.

  • Open the flap revealing the cable inputs and remove the final screw (3.8mm, Phillips #00) found inside.

Schritt 2  ¶ 

Turn the camera so that the LCD screen is facing you.

Schritt 2  ¶ 

  • Turn the camera so that the LCD screen is facing you.

  • Remove the back panel by pulling it off of the camera.

Schritt 3  ¶ 

Turn the camera so that the lens is facing you. Do not pull the front panel off without removing the ribbon cable first. Slowly lift the front panel from the camera.

Schritt 3  ¶ 

  • Turn the camera so that the lens is facing you.

  • Do not pull the front panel off without removing the ribbon cable first.

  • Slowly lift the front panel from the camera.

  • The ribbon cable is connecting the front panel to the camera. Using the tweezers, gently pull the ribbon cable out of its socket.

  • A spudger may also be used to remove the ribbon cable.

  • Remove the rubber guard that rests on top of the lens.