Zum Hauptinhalt wechseln
Hilfe

iPod Shuffle 1st Generation Battery & Logic Board Replacement

Empfohlene Anleitung

Empfohlene Anleitung

Diese Anleitung wird von den iFixit-Mitarbeitern als außergewöhnlich gut eingestuft.

  • Autor: iRobot
  • Schwierigkeitsgrad: Sehr schwierig

The motherboard of your iPod controls everything in the iPod.

Abschnitte
Werkzeuge

Schritt 1 Battery & Logic Board  ¶ 

Gently pull back the white plastic framework to free the left edge of the logic board. Pull up on the logic board slightly to prevent the logic board from falling back into place.

Schritt 1 Battery & Logic Board  ¶ 

  • Gently pull back the white plastic framework to free the left edge of the logic board. Pull up on the logic board slightly to prevent the logic board from falling back into place.

Schritt 2  ¶ 

Repeat the same procedure on the opposite side to free the logic board from the white plastic casing.

Schritt 2  ¶ 

  • Repeat the same procedure on the opposite side to free the logic board from the white plastic casing.

Schritt 3  ¶ 

Lift the logic board up to disconnect it from the memory board beneath. Don't remove the logic board from the iPod yet, because it's still connected to the battery.

Schritt 3  ¶ 

  • Lift the logic board up to disconnect it from the memory board beneath. Don't remove the logic board from the iPod yet, because it's still connected to the battery.

Schritt 4  ¶ 

Turn the iPod over and use your finger to push the battery through the hole in the casing. The battery is attached to the plastic framework with a mild adhesive.

Schritt 4  ¶ 

  • Turn the iPod over and use your finger to push the battery through the hole in the casing. The battery is attached to the plastic framework with a mild adhesive.

  • Lift the battery and logic board out of the iPod.