Zum Hauptinhalt wechseln
Hilfe

Retina MacBook 2015 Right Speaker Replacement

Replace the right speaker in the Retina MacBook 2015.

Replace the right speaker on your Retina MacBook 2015. Part of the wireless antenna is also integrated into the right speaker. Use this guide to replace both the speaker and antenna as a single unit.

To avoid logic board damage, when your MacBook repair is complete but before powering it on, connect it to low-voltage power using a 5-Watt iPhone charger and a USB-C to USB-A cable. These accessories are not included with your MacBook, so make sure you have them ready before you begin.

Schritt 1 Right Speaker  ¶ 

Using tweezers, remove the foam pad covering the screw on the left side of the right speaker.

Schritt 1 Right Speaker  ¶ 

  • Using tweezers, remove the foam pad covering the screw on the left side of the right speaker.

  • If you pull on the foam portion, it will tear. Try to get your tweezers under the adhesive pad holding the foam to the top of the screw.

Schritt 2  ¶ 

Remove the two 4.1 mm T3 Torx screws securing the right speaker.

Schritt 2  ¶ 

  • Remove the two 4.1 mm T3 Torx screws securing the right speaker.

Schritt 3  ¶ 

Using tweezers, carefully peel up the tape securing the right antenna cable to the lower case. Using tweezers, carefully peel up the tape securing the right antenna cable to the lower case. Using tweezers, carefully peel up the tape securing the right antenna cable to the lower case.

Schritt 3  ¶ 

  • Using tweezers, carefully peel up the tape securing the right antenna cable to the lower case.

Schritt 4  ¶ 

Prepare an iOpener and heat the lower case directly beneath the right speaker for 1-2 minutes, in order to soften up the adhesive securing the speaker.

Schritt 4  ¶ 

  • Prepare an iOpener and heat the lower case directly beneath the right speaker for 1-2 minutes, in order to soften up the adhesive securing the speaker.

Schritt 5  ¶ 

Use a plastic opening tool to pry under the top edge of the right speaker, and separate it from the lower case. Use a plastic opening tool to pry under the top edge of the right speaker, and separate it from the lower case. Use a plastic opening tool to pry under the top edge of the right speaker, and separate it from the lower case.

Schritt 5  ¶ 

  • Use a plastic opening tool to pry under the top edge of the right speaker, and separate it from the lower case.

Schritt 6  ¶ 

Remove the right speaker.

Schritt 6  ¶ 

  • Remove the right speaker.