Zum Hauptinhalt wechseln
Hilfe

Samsung Galaxy S6 Battery Replacement

Empfohlene Anleitung

Empfohlene Anleitung

Diese Anleitung wird von den iFixit-Mitarbeitern als außergewöhnlich gut eingestuft.

Replace the battery in your Samsung Galaxy S6.

  • Autor: Dante Mazzanti
  • Geschätzte Zeit: 40 Minuten - 1 Stunde
  • Schwierigkeitsgrad: Schwierig

Use this guide to replace the battery in your Samsung Galaxy S6.

Before disassembling your phone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

If your battery is swollen, take appropriate precautions. Do not heat your phone. If needed, you can use a dropper or syringe to inject isopropyl alcohol (90+%) around the edges of the back cover to weaken the adhesive. Swollen batteries can be very dangerous, so wear eye protection and exercise due caution, or take it to a professional if you're not sure how to proceed.

This guide involves removing the rear glass. Removing the rear glass destroys the adhesive holding it in place. Follow this guide to reinstall the rear glass.

Schritt 1 Battery  ¶ 

Insert a plastic opening pick between the case and the battery. Be careful to keep the pick as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals. Push the pick further in to separate the battery from the phone.

Schritt 1 Battery  ¶ 

  • Insert a plastic opening pick between the case and the battery.

  • Be careful to keep the pick as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Push the pick further in to separate the battery from the phone.

  • If the battery is too strongly adhered for the opening pick, place a warm iOpener over the battery to loosen the adhesive.

  • Alternatively, apply some isopropyl alcohol under each corner of the battery and allow it to penetrate for several minutes to help weaken the adhesive.

  • Do not pry against the motherboard or you may damage the phone.

Schritt 2  ¶ 

Remove the battery from the phone. Do not reuse the battery after it has been removed, as doing so is a potential safety hazard. Replace it with a new battery.

Schritt 2  ¶ 

  • Remove the battery from the phone.

  • Do not reuse the battery after it has been removed, as doing so is a potential safety hazard. Replace it with a new battery.

  • To install a new battery:

  • Remove any remaining adhesive from the phone, and clean the glued areas with isopropyl alcohol and a lint-free cloth.

  • Secure the new battery with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the phone, not directly onto the battery. The adhesive should go around the perimeter of the battery compartment, but not in the rectangular cutout in the center (which is actually the back side of the display).

  • Press the battery firmly into place for 5-10 seconds.