Zum Hauptinhalt wechseln
Hilfe

Nikon N2000 (F301) Communication Board Replacement

Action Shots

Action Shots

Sei ein Actionheld! Diese Anleitung benötigt Bilder, damit besser veranschaulicht werden kann, wie bestimmte Handgriffe ausgeführt werden.

Grundständige Anleitungen passen nicht zueinander

Grundständige Anleitungen passen nicht zueinander

Diese Anleitung hat keine passende grundständige Anleitung. Hilf mit, indem du ihr Gegenstück findest oder schreibst!

Fehlende grundständige Anleitungen

Fehlende grundständige Anleitungen

In dieser Anleitung fehlen Informationen, wie man am besten anfängt. Erstelle eine grundständige Anleitung!

How to remove and replace the communication board from the inside of the camera.

  • Autor: Zachary Phillips
  • Geschätzte Zeit: 10 - 15 Minuten
  • Schwierigkeitsgrad: Moderat

The communication board sends information about the aperture and focus of the lens. If you are having trouble with focus or aperture, then there may be a problem with the communication board.

Schritt 1 Communication Board  ¶ 

Remove the three loose parts (spring, small rod, and metal ring) that were under the lens mount and put them aside.

Schritt 1 Communication Board  ¶ 

  • Remove the three loose parts (spring, small rod, and metal ring) that were under the lens mount and put them aside.

  • Make sure you remember the orientation of the metal ring so that it is easier to put back in the device later.

Schritt 2  ¶ 

Use 00 Phillips head screwdriver to remove the screw from the bottom of the front black case.

Schritt 2  ¶ 

  • Use 00 Phillips head screwdriver to remove the screw from the bottom of the front black case.

Schritt 3  ¶ 

Use 00 Phillips head screwdriver to remove the screws from the top case (6 in all). Use 00 Phillips head screwdriver to remove the screws from the top case (6 in all). Use 00 Phillips head screwdriver to remove the screws from the top case (6 in all).

Schritt 3  ¶ 

  • Use 00 Phillips head screwdriver to remove the screws from the top case (6 in all).

Schritt 4  ¶ 

Remove the front case from the camera.

Schritt 4  ¶ 

  • Remove the front case from the camera.

  • There is a black plastic ring in the case. Be sure not to remove it, as it can be difficult to put back.

Schritt 5  ¶ 

Use a 00 Phillips head screwdriver to remove the screws from either side of the communication board.

Schritt 5  ¶ 

  • Use a 00 Phillips head screwdriver to remove the screws from either side of the communication board.

Schritt 6  ¶ 

Desolder the wires and remove them from the communication board.

Schritt 6  ¶ 

  • Desolder the wires and remove them from the communication board.

  • Note: If you are unfamiliar with soldering techniques, click here for a guide.