Zum Hauptinhalt wechseln
Hilfe

Repairing TOYOTA COROLLA Dashboard Clock

Benötigt Mehr Bilder

Benötigt Mehr Bilder

Einige Bilder mehr würden die Vorgehensweise in dieser Anleitung deutlich klarer machen.

Anleitung eines Mitglieds

Anleitung eines Mitglieds

Ein großartiges Mitglied unserer Community hat diese Anleitung erstellt. Sie wird nicht von iFixit Mitarbeitern überprüft.

Dashboard clock can lose LCD segments or get dim. This can usually fix it. It requires minimal mechanical and soldering skills. Replacement clock from dealer is over $300.

  • Autor: Steve Mathias
  • Geschätzte Zeit: 20 Minuten
  • Schwierigkeitsgrad: Moderat

This will teach you how to remove the clock, resolder the circuit board, and reinstall the clock.

You can also find a youtube video at

http://www.youtube.com/watch?v=lFwKA2dDb...

Schritt 1 Dashboard Clock  ¶ 

First, pry the trim up from around the shift lever, lifting straight up. Then, pull the fan speed knob out from the dashboard. Remove the screw from behind it.

Schritt 1 Dashboard Clock  ¶ 

  • First, pry the trim up from around the shift lever, lifting straight up. Then, pull the fan speed knob out from the dashboard. Remove the screw from behind it.

Schritt 2  ¶ 

You'll need to carefully pull the whole instrument cluster out of the dashboard. The plastic clips circled in red are what is holding it in, so carefully pry there. A putty knife or other thin blade may help.

Schritt 2  ¶ 

  • You'll need to carefully pull the whole instrument cluster out of the dashboard. The plastic clips circled in red are what is holding it in, so carefully pry there. A putty knife or other thin blade may help.

Schritt 3  ¶ 

Kein Bild

Schritt 3  ¶ 

  • There are little plastic tabs that hold the clock into the dash panel, so pull them back a little to release the clock. Remove the electical connector by pressing the tab on the side of the connector.

Schritt 4  ¶ 

Pry up the black tabs, 2 top and 2 bottom, to release the face of the clock.

Schritt 4  ¶ 

  • Pry up the black tabs, 2 top and 2 bottom, to release the face of the clock.

  • Find the 5 black devices on the circuit board. Here they are labeled 270, 510, and 3 at 181. These are what need to be resoldered.

  • Carefully remelt the solder at each end of each device. You probably don't need to add any solder, and you don't want to make any solder bridges where they shouldn't be.

Schritt 5  ¶ 

Kein Bild

Schritt 5  ¶ 

  • You can now plug the clock back in and see if it works. If so, put it all back together:

  • Snap the clock back together, and back into its place in the dashboard.

  • Snap the dashboard back in place. Put the screw back in behind the fan knob. Put the fan knob back in.