Zum Hauptinhalt wechseln
Hilfe

MacBook Pro 15" Unibody Early 2011 AirPort/Bluetooth Board Assembly Replacement

Nicht eigenständige Anleitung

Nicht eigenständige Anleitung

Bitte beachte, dass diese Anleitung nur eine grundständige Anleitung für andere Anleitungen ist.

AirPort/Bluetooth Board Assembly prereq.

This guide is prereq only.

Schritt 1 AirPort/Bluetooth Board Assembly  ¶ 

Pull the camera cable connector straight out of its socket on the logic board.

Schritt 1 AirPort/Bluetooth Board Assembly  ¶ 

  • Pull the camera cable connector straight out of its socket on the logic board.

  • Pull the cable parallel to the face of the logic board toward the optical drive opening.

Schritt 2  ¶ 

Use the flat end of a spudger to carefully pry the AirPort/Bluetooth ribbon cable up off its socket on the logic board.

Schritt 2  ¶ 

  • Use the flat end of a spudger to carefully pry the AirPort/Bluetooth ribbon cable up off its socket on the logic board.

Schritt 3  ¶ 

Use the tip of a spudger to pry the four antenna connectors up from their sockets on the AirPort/Bluetooth board. Use the tip of a spudger to pry the four antenna connectors up from their sockets on the AirPort/Bluetooth board.

Schritt 3  ¶ 

  • Use the tip of a spudger to pry the four antenna connectors up from their sockets on the AirPort/Bluetooth board.

Schritt 4  ¶ 

De-route all four antenna cables from their channels in the AirPort/Bluetooth housing. De-route the camera cable from its channel in the AirPort/Bluetooth housing. De-route the camera cable from its channel in the AirPort/Bluetooth housing.

Schritt 4  ¶ 

  • De-route all four antenna cables from their channels in the AirPort/Bluetooth housing.

  • De-route the camera cable from its channel in the AirPort/Bluetooth housing.

Schritt 5  ¶ 

Remove the following two screws securing the AirPort/Bluetooth assembly to the upper case:

Schritt 5  ¶ 

  • Remove the following two screws securing the AirPort/Bluetooth assembly to the upper case:

  • One 8.6 mm Phillips screw

  • One 3.9 mm Phillips screw

Schritt 6  ¶ 

Remove the AirPort/Bluetooth assembly from the upper case, minding any cables that may get caught.

Schritt 6  ¶ 

  • Remove the AirPort/Bluetooth assembly from the upper case, minding any cables that may get caught.