Zum Hauptinhalt wechseln
Hilfe

Nintendo 3DS Lower Display Assembly Replacement

Lower display assembly removal

If both the LCD and touchscreen of your lower display are bad, then you'll have to replace the whole thing.

Abschnitte

Schritt 1 Lower Display Assembly  ¶ 

Set the motherboard assembly down so that the lower LCD is side-by-side with the motherboard. Use the tip of a spudger or your fingers to peel back the white tape covering the touchscreen ribbon cable connector. Use the tip of a spudger or your fingers to peel back the white tape covering the touchscreen ribbon cable connector.

Schritt 1 Lower Display Assembly  ¶ 

  • Set the motherboard assembly down so that the lower LCD is side-by-side with the motherboard.

  • Use the tip of a spudger or your fingers to peel back the white tape covering the touchscreen ribbon cable connector.

Schritt 2  ¶ 

Use the flat end of a spudger or your fingernail to flip up the retaining flap on the touchscreen ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself.

Schritt 2  ¶ 

  • Use the flat end of a spudger or your fingernail to flip up the retaining flap on the touchscreen ribbon cable ZIF socket.

  • Be sure you are prying up on the hinged retaining flap, not the socket itself.

Schritt 3  ¶ 

Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD power ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself. Pull the ribbon cable out of the connector with a pair of tweezers.

Schritt 3  ¶ 

  • Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD power ribbon cable ZIF socket.

  • Be sure you are prying up on the hinged retaining flap, not the socket itself.

  • Pull the ribbon cable out of the connector with a pair of tweezers.

  • Grasp the ribbon cable as close to the connector as possible with the tweezers to avoid tearing it.

Schritt 4  ¶ 

Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD data ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself.

Schritt 4  ¶ 

  • Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD data ribbon cable ZIF socket.

  • Be sure you are prying up on the hinged retaining flap, not the socket itself.

Schritt 5  ¶ 

Grasp the lower display assembly and pull it directly away from the motherboard.

Schritt 5  ¶ 

  • Grasp the lower display assembly and pull it directly away from the motherboard.