Zum Hauptinhalt wechseln
Hilfe

HTC Wizard 200 Screen Cover Replacement

Fehler in den Markups

Fehler in den Markups

Diese Anleitung benötigt bessere Markups. Hilf aus, indem du sie korrigierst oder einige Markup-Anmerkungen erstellst.

Installation of the screen cover on the HTC Wizard 200.

This guide will explain how to install / remove the screen cover from the HTC Wizard 200.

Abschnitte

Schritt 1 Screen Cover  ¶ 

Use the T5 Torx screwdriver to remove four 5mm screws that secure the back of the screen casing. Use the T5 Torx screwdriver to remove four 5mm screws that secure the back of the screen casing.

Schritt 1 Screen Cover  ¶ 

  • Use the T5 Torx screwdriver to remove four 5mm screws that secure the back of the screen casing.

Schritt 2  ¶ 

Insert the plastic opening tool between the front panel and the rear panel and pry open to reach the screen. Insert the plastic opening tool between the front panel and the rear panel and pry open to reach the screen.

Schritt 2  ¶ 

  • Insert the plastic opening tool between the front panel and the rear panel and pry open to reach the screen.

Schritt 3  ¶ 

Once the rear panel is loose, lift it off of the front panel. The flexible connection will pop loose.

Schritt 3  ¶ 

  • Once the rear panel is loose, lift it off of the front panel.

  • The flexible connection will pop loose.

Schritt 4  ¶ 

Device rotated 90 degrees CCW.

Schritt 4  ¶ 

  • Device rotated 90 degrees CCW.

  • Remove the yellow anti-static tape.

Schritt 5  ¶ 

Unscrew the two 3mm phillips #0 screws from the bottom of the device that secure the rigid flex board to the screen panel. Unscrew the two 3mm phillips #0 screws from the bottom of the device that secure the rigid flex board to the screen panel.

Schritt 5  ¶ 

  • Unscrew the two 3mm phillips #0 screws from the bottom of the device that secure the rigid flex board to the screen panel.

Schritt 6  ¶ 

Device rotated 180 degrees CW.

Schritt 6  ¶ 

  • Device rotated 180 degrees CW.

  • Unscrew the two 3mm phillips #0 screws from the top of the device that secure the rigid flex board to the screen panel.

Schritt 7  ¶ 

Device rotated 90 degrees CCW.

Schritt 7  ¶ 

  • Device rotated 90 degrees CCW.

  • Unhinge the flexible connection and use the tweezers to disconnect.

Schritt 8  ¶ 

Now that the rigid flex board is loose, remove it from the screen.

Schritt 8  ¶ 

  • Now that the rigid flex board is loose, remove it from the screen.