iBook G4 14" 1.42 GHz Lower Case Replacement
- Autor: Walter Galan
- Schwierigkeitsgrad: Moderat
Replacing the plastic bottom case.
Bette diese Anleitung ein
Wähle eine Größe und kopiere den nachfolgenden Code, um diese Anleitung als kleines Widget auf deiner Seite / in deinem Forum einzubetten.
Schritt 1 — Lower Case ¶
Close the display and flip the computer over.
Remove the three hex screws using a T8 Torx screwdriver.
Schritt 2 ¶
Use a spudger or small flathead screwdriver to remove the three rubber feet from the lower case.
Schritt 3 ¶
Remove the three newly-revealed Phillips screws.
Schritt 4 ¶
Use a spudger or small flathead screwdriver to pry up the three metal rings that housed the rubber bumpers.
Schritt 5 ¶
Remove the two Phillips screws on either side of the battery contacts.
Schritt 6 ¶
Push in the thin rims of the lower case surrounding the battery compartment, bending them past the tabs, and then lift up to free that corner of the lower case.
Schritt 7 ¶
There is a slot on the wall of the battery compartment that locks the lower case in place. Use a small flathead screwdriver to pry out the slot's lower rim and pull up on the lower case to free the slot from the tabs holding it.
Schritt 8 ¶
Run a spudger along the seam between the lower case and upper case on the front of the computer to free the tabs locking the lower case. Pull up on the lower case and continue to use the spudger as necessary until you hear three distinct clicks.
Schritt 9 ¶
Continue to run the spudger around the front, right corner. There are two tabs on the port side of the computer, one near the front corner and one near the sound-out port.
Schritt 10 ¶
There are three tabs over the optical drive that must be released before the lower case can come off. Slide the spudger into the lower case above the optical drive and run it toward the back of the computer until you hear three distinct clicks.
Schritt 11 ¶
Turn the computer so that the back is facing you and pull the lower case up and toward you until the back tabs pop free.
Schritt 12 ¶
Remove the small greasy springs with white plastic caps from either side of the battery contacts.