MacBook Pro 13" Function Keys Late 2016 Lower Case Replacement
Remove the lower case on your non-Touch Bar MacBook Pro (2016, Two Thunderbolt 3 ports), either to replace it or to access the internals for further repair.
- Autor: Jeff Suovanen
- Geschätzte Zeit: 5 - 10 Minuten
- Schwierigkeitsgrad: Moderat
This serves as the starting point for every repair on your MacBook Pro. You'll need a P5 Pentalobe screwdriver to remove the lower case and get into the device.
For your safety, discharge your MacBook Pro's battery before you begin this procedure. A charged lithium-ion battery can create a dangerous and uncontrollable fire if accidentally punctured.
Bette diese Anleitung ein
Wähle eine Größe und kopiere den nachfolgenden Code, um diese Anleitung als kleines Widget auf deiner Seite / in deinem Forum einzubetten.
Schritt 1 — Lower Case ¶
Use a P5 Pentalobe driver to remove the six screws securing the lower case:
Two 6.2 mm screws
Two 5.3 mm screws
Two 3.4 mm screws
Schritt 2 ¶
Apply a suction handle to the lower case near the front-center area of the MacBook Pro.
Lift the suction handle to create a slight separation between the lower case and the chassis.
Schritt 3 ¶
Insert one corner of an opening pick into the space between the lower case and the chassis.
Slide the opening pick around the nearest corner and halfway up the side of the case.
Schritt 4 ¶
Repeat the previous step on the opposite side, sliding your opening pick under the lower case and up the side to pop the second clip free.
Schritt 5 ¶
Insert your opening pick once again under the front edge of the lower case, near one of the two centermost screw holes.
Give the pick a firm twist to pop free the third clip securing the lower case to the chassis.
Repeat this procedure near the other of the two centermost screw holes, popping the fourth clip free.
Schritt 6 ¶
Pull the lower case firmly towards the front of the MacBook (away from the hinge area) to separate the last of the clips securing the lower case.
Schritt 7 ¶
Remove the lower case.